CQ World Wide 160-Meter Contest
CQ World Wide 160-Meter Contest
| Call | Category | Comments |
|---|---|---|
| PA3DTR | ASSISTED LOW | Antenna used is a tillted L-antenna. Single wire 30 feet up. Good propagation, fun to participate. Tnx! |
| PA3EVY | ASSISTED LOW | dipole 80/160 |
| PA3FGA | ASSISTED HIGH | Did a last minute prepare to enable PA5MW use of my station for a few hours on Saterday evening. As the station was setup I decided to do some S&P and participate a few hours. After going to sleep around 03:15 local I expected to wake-up at the usual go t |
| PA4WM | ASSISTED HIGH | With my portable antenna still underway from Swains to home, I had to improvise with a piece of wire. Zigzagging from feedpoint to top of the mast and back into the small city lot. The most crooked antenna you've ever seen HI. Dist it work?... Mw Had fun |
| PA5MW | ASSISTED HIGH | Exactly like last year, I spent a few hours at a friend's place just for the FUN of it. K3+KPA500 + 3.5Mhz Inv-L +series coil +16x5m radials in a tiny backyard. Many thanks to Rens PA3FGA.Hope to be QRV at my own QTH in 2025 again. 73 Mark PA5MW |
| PA9M | ASSISTED LOW | vertical 10m vertical and slooping 13m, in the centre of the city. No RX antenne. noisy and qrm |
| PC5Q | ASSISTED LOW | Antenna: inverted v with apex at 12 meter above ground. |
| PC8M | ASSISTED LOW | Nice to make some contacts on 160m. A new band for me and only used 2 x 15m doublet fed with ladderline and a symmetrical tuners. Thanks to all ops in this contest to take the time to make a qso with me :-) |
| PE5TT | ASSISTED LOW | endfed wire about 12 long with remote antenna tuner |
| PJ4DX | ASSISTED HIGH | After more than 10 years and 135,000 QSOs, PJ4DX is now going QRT. The 160m inverted-L is coming down in the next few days. I am relocating to England. Thanks for all the QSOs over the years. IC-7300, Acom 1500, inverted-L. No RX antennas. 73 Steve, PJ4DX |
| PV8DX | ASSISTED HIGH | slooper antenna. TOWER 15m |
| PY2GTA | ASSISTED LOW | my antena is simple dipole, balun 1.1, center 25m ground above, side 10m above. |
| R2AJA | SINGLE-OP QRP | FT-891+ LW 40M Long |
| R2FC | ASSISTED LOW | inverted Z |
| R3PIQ | SINGLE-OP LOW | GL! 73! |
| RA1OHX | ASSISTED HIGH | 73! |
| RA3V | SINGLE-OP LOW | FT 840 |
| RA3XCZ | SINGLE-OP LOW | IC756PROIII, Delta Loop 160 73! |
| RC7KF | ASSISTED LOW | Inverted V |
| RD5R | ASSISTED LOW | Dipole 15m above ground |
| RM4F | ASSISTED HIGH | TNX 73! |
| RT1L | ASSISTED HIGH | Antenna - Inverted L (47metr long, up 17m). TRX - SunSdr2Pro PA - ACOM1000 (abt. 600W) |
| RU3DNN | ASSISTED LOW | Inv-V |
| RU3UR | SINGLE-OP HIGH | mike73@rambler.ru |
| RU6CO | SINGLE-OP LOW | To all tnx&73! Ant is Sloper up 14m. |
| RU6K | ASSISTED LOW | Not symmetric wave dipole about 17 meters at its highest point |
| RU9AC | SINGLE-OP LOW | 73! single-element antennas such as a vertical |
| RW3AI | SINGLE-OP QRP | Xiegu G90 power 5 watts, Ant LW 120m |
| RX3VF | SINGLE-OP LOW | IC 746, LW |
| S50IPA | SINGLE-OP LOW | WIRE VERTICAL , 8m to 3m above the ground |
| S51DD | SINGLE-OP LOW | wire vertical,10m above the ground at its highest point |
| S51DX | SINGLE-OP HIGH | Slooping dipole - west. |
| S51J | ASSISTED HIGH | Working from home. I spread my Kelemen DP-1608040-H-P between near tree and up to the bottom of sprunce on the slope near to the house. So the center was not very high from the ground, and it was more like an ENVIS antenna HI. So only EU came through! I w |
| S51RW | ASSISTED LOW | Flex-3000, 50w, 20m wire with loaded coil, @5m |
| S52KJ | SINGLE-OP QRP | 23m Long end-fed half wave antenna with a loading coil 5m above ground |
| S53R | ASSISTED HIGH | It was fun sitting in Kathmandu/9N7AA and operating S53R remotely! |
| S54X | ASSISTED LOW | multiband 160/80/40m dipole used |
| S55KA | ASSISTED LOW | End-fed wire antena, home made, no balun. 8 m above the ground. |
| S56C | ASSISTED LOW | I use only Long Wire, single element antenna. Actually it is middle wire of mine FD4 anttenna for 80m S5&C |
| S57KM | ASSISTED LOW | Windom antenna, 15m above ground. |
| S57SU | SINGLE-OP LOW | DIPOLE A FEW METERS ABOVE GROUND |
| S57W | ASSISTED HIGH | Inverted L at 15 m, 30 m long beverage to NW, IC-781, 800 W |
| S58MU | SINGLE-OP LOW | WIRE VERTICAL , 8m to 3m above the ground |
| S59BDE | SINGLE-OP LOW | SIMPLE DIPOLE |
| S59DR | ASSISTED LOW | Dipole, 7m above gnd |
| S59IPA | SINGLE-OP LOW | wire vertical 10m above the ground |
| SA2CLC | ASSISTED HIGH | Fun to try 160m. Goal was to work US, did not happen. perhaps next year with better antenna. Rig: K3, homebrew 800W 2x813 linear. Ant. 12m vert with combination top/base loading. |
| SD6F | ASSISTED LOW | Inverted L with 12m vertical part with 25 radials on ground |
| SE6K | SINGLE-OP LOW | Inverted L antenna |
| SM5CSS | SINGLE-OP LOW | Elecraft K3 100W to elevated Inverted-L antenna. The base and the two radials elevated 2m from ground. The vertical wire element goes 15m up and then it is sloping down towards the ground. |